Tech TipKuhltek universal electric ignition kit for VW Type 1. Includes magnetic trigger collar, sensor and hardware. Direct bolt on for 009 style distributors. Must be used with 3.0 ohm coil.
California Prop 65 Warning:
Warning: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
- Additional Information
Don't get burned. Electronic Ignition Install Tips:
1. Make sure your engine is wired up properly. The only wires that should be on your coil's negative terminal are a tachometer signal and the negative of the electronic ignition.
2. Make sure you have the right coil. Check the specs on your electronic ignition unit. All standard electronic ignition units require a coil with no less than 3.0 ohms of resistance. Common compatible coils are the Bosch Blue, Beru Blue and Pertronix 3.0 ohm flamethrower.
3. Don't leave the key on! Make sure to not keep the key switched to "on" when the engine is not running. If you need to leave it on for trouble shooting disconnect the electronic ignition unit or it can overheat and fail.
4. Enjoy it! Your car should run smooth and be less finicky with an electronic ignition. Get out and cruise! This eliminates point adjustment and allows for a smoother running engine. This unit can be used in Bosch/VW-style aftermarket distributor housings, which means that factory cap and rotors are retained for easy servicing.
|Oversized Shipping Required||No|